Whirlpool Oven Error Codes: F-Code List & Fixes
Whirlpool’s F-series codes, fully decoded — what each means, the reset to try, and the real cost when it persists.
✓ Full F-series list ✓ Reset protocol ✓ Same-day repair
Whirlpool Oven Error Codes, Decoded
Whirlpool’s two-part codes (F_E_) pinpoint the subsystem.
| Code | Meaning | Try First | Typical Repair |
|---|---|---|---|
| F1E0 | Control board failure | Reset once | Board $150–$600 |
| F1E1 | Control / EEPROM fault | Reset once | Board $150–$600 |
| F2E0 | Keypad disconnected | Reseat; reset | Keypad $150–$350 |
| F2E1 | Keypad stuck key | Reset; clean | Keypad $150–$350 |
| F3E0 | Sensor open/short | Reset; check wiring | Sensor $100–$350 |
| F3E1 | Sensor out of range | Reset | Sensor $100–$350 |
| F5E0 | Door switch fault | Reset | Switch $100–$250 |
| F5E1 | Door latch fault | Cool down; reset | Latch $120–$300 |
| F6E0 | Communication fault | Reset once | Board $150–$600 |
Brand overview: Whirlpool oven repair →
Before You Call: The Reset Protocol
One proper reset rules out every transient fault.
Universal Reset Protocol (Try First)
- Note the code. Photograph the display — codes can clear on reset and we’ll want to know which one appeared.
- Breaker off, 60 seconds. Flip the oven’s breaker fully OFF, wait a full minute, flip back ON. This clears transient faults.
- Reset the clock. Many ovens won’t heat until the clock is set after a power cycle.
- Test one function. Try Bake at 350°F. If the code returns immediately, it’s a hard fault — stop resetting and call us.
- Don’t repeat endlessly. Three failed resets = real failure. Repeated power-cycling won’t fix a bad sensor or board.
Whirlpool Error Code FAQs
Quick answers for Whirlpool owners.
What does F1E0 mean on my Whirlpool oven?
F1E0 is a control-board failure — the board’s self-test failed. One reset is worth trying; a returning F1E0 means board replacement ($150–$600).
My Whirlpool shows F2E0. Is the keypad dead?
F2E0 means the keypad disconnected from the board — sometimes just a loose ribbon cable (reseat + reset fixes it), sometimes a dead keypad ($150–$350). We check the connection first.
What’s the difference between F3E0 and F3E1?
F3E0 = sensor circuit open or shorted; F3E1 = sensor reading out of expected range (drifting). Both end at a $100–$350 sensor — we meter-test to confirm.
My Whirlpool shows F6E0. What does that mean?
F6E0 is a communication fault between boards (common on double ovens with two control boards). It needs board-level diagnosis — The diagnostic covers it.
Can I clear Whirlpool error codes myself?
Transient codes: yes, with the 60-second breaker reset. Hard faults (returning codes): no — the part has failed. Three strikes and it’s a repair call: (971) 399-8141.
Code You Can’t Clear? We’ll Decode It In Person.
Same-day diagnosis in Beaverton — flat-rate pricing, quoted and approved before any work begins.